This controller has been designed for use in radio control aircraft and to support continuous currents of up to 10 amps when using 2–3 cell Li-Po battery packs and up to 4 sub-micro servos. Standard features include advance BEC and safe power-arming along with programmable features such as low-voltage cutoff, braking, timing and throttle input range.
Features
- Up to 10-amp continuous current with proper air flow
- Programmable motor braking
- Safe power-arm mode prevents accidental starts
- Programmable low-voltage cutoff with settings for 2-cell Li-Po (6V), 3-cell Li-Po (9V) or 70% of battery starting voltage
- Programmable throttle input range (1.1ms–1.9ms or Auto Select)
- Auto motor shut down if signal is lost or there is interference
- Programmable timing—2 user-selectable ranges for use with a large variety of brushless motors
- Pre-wired connectors—JST on battery input and 2mm female gold bullets on motor output leads
- Soft start
In Depth
- Brake: Yes - Programmable
- Continuous Maximum Current: 10A
- Input Connector Types: 20AWG with JST connector
- Output Connector Types: 20AWG with 2mm Female Gold Bullet Connectors
- Momentary Peak Current: 12A (15 sec)
- Length: 1.2 in (30mm)
- Width: 0.7 in (17.5mm)
- Height: 0.4 in (10mm)
- Weight: 0.35 oz (10g)
- Cells w/BEC: 2-3S Li-Po or 6-10 Ni-MH/Ni-Cd
