An updated version of our original Pixie-7, the Pixie-7P provides modelers flexibility through the use of user-programmed features. Using an on-board LED and your throttle stick, you decide the cut-off voltage, motor cut-off, and throttle range options on this ESC! The Pixie-7P can be used with Speed-280 and smaller motors where current draw will be 7 amps or less. It comes with custom-made 24 gauge silicone wire for battery and motor leads. The Pixie-7P can be set up for lower cut-off voltages for 3 or 4 cell NiCad packs, higher cut-offs for lithium cells or 10-16 cell NiCad packs, or no cut-off for micro helis. The unit comes pre-programmed for standard 5-10 cell aircraft operation (4.7V cut-off).
Features
- Battery Eliminator Circuit (BEC): eliminates receiver battery
- Safe "Power On"
- Low torque "Soft Start": protects gear boxes and belt drives from shock
- Simple setup: no complicated switches or wiring
- Tough surface mount construction
- Smooth reverse exponential throttle
- Audible Arming Signal
- Self-calibrating endpoints: maximizes usable stick travel
- Auto Motor cut-off with reset
- Auto shut-down when signal is lost
- Microprocessor Controlled
In Depth
- Forward: yes
- Reverse: no
- Brake: no
- Continuous Maximum Current: 7A
- Input Connector Types: Universal
- Output Connector Types: Universal
- Dimensions (WxLxH): 0.28" x 0.58" x 0.03"
- Weight: 0.11 oz
- Cells w/BEC: 3-8
- Cells w/o BEC: 3-18